3326 East Smith Road
Medina, OH 44256

Tel: 330.722.3729
Fax: 330.723.0451

Codeman says . . . .

Our steam is well contained.

Projects

Pressure Vessel Jacket on Horizontal Tank

ASME Code Section VIII Div. 1 – 75 psig pressure vessel jacket for horizontal mixing tank.

Scope: Shell thickness (internal and external pressure), nozzle thickness, nozzle reinforcement, jacket closure, stiffening ring calculation, weld design, jacket fabrication drawing.

Nozzle Installation in Existing Tank

ASME Code Section VIII Div. 1 – 50 psig nozzle in 316 SS fermenter tank.

Scope: Shell thickness, nozzle thickness, nozzle reinforcement, weld design.

Manway Installation in Boiler Mud Drum

ASME Code Section I – 350 psig manway in boiler mud drum.

Scope: Drum thickness, drum head thickness, manway ring thickness, weld design, installation drawing.

Pressure Vessel Evaluation

ASME Code Section VIII Div. 1 – 700 psig accumulator pressure vessel.

Scope: shell and head thickness, nozzle thickness, nozzle reinforcement, weld design, vessel weight and volume calculations.

Boiler Replacement Floor Tube Header

ASME Code Section 1 – 1000 psig floor header.

Scope: shell and head thickness, nozzle thickness, nozzle reinforcement, weld design, vessel weight and volume calculations, fabrication drawing.

Stainless Steel Solvent Tank

ASME Code Section VIII Div. 1 – 100 psig

SCOPE: shell and head thickness, nozzle thickness, nozzle reinforcement, weld design, vessel weight and volume calculations, fabrication drawing.

Storage Tank

ASME Code Section VIII Div. 1 – 30 psig – 120” O.D. x 50’ high

Scope: shell and head thickness, nozzle thickness, nozzle reinforcement, weld design, vessel weight and volume, wind load calculations, skirt design, base ring, anchor bolt and lifting lug design, fabrication drawing

Heat Exchanger Rerate

ASME Code Section VIII Div. 1 – 150 psig, chlorine service

Scope: shell thickness, confirm measured thickness

Demonstration Vessel for Joint Review – Division 2

ASME Code Section VIII Div. 2 – 300 psig

Scope: Wrote User Design Specification, Manufacturer’s Design Report consisting of shell thickness, head thickness, nozzle thickness, nozzle reinforcement using ASME Code Section VIII Division 2 rules. Fabrication drawing, Registered Professional Engineer Stamped

Locomotive and Steam Traction Engine Boiler Evaluation & Design

ASME Code Section I – 300 psig

Scope: Material thickness calculations for tubesheets, boiler drum, firebox, mud ring, firetubes, staybolts of traction engine and locomotive boilers.

70' Stack Design & Fabrication Drawing

IBC 2006 Wind & Seismic considerations

Scope: Shell thickness design & fabrication drawing

Horizontal Tank Saddle Support Design

ASME Code Section VIII Division 1, L.P. Zick saddle analysis

Scope: Saddle support design for ethanol tank

Skid Design - Equipment Packages

Pre-piped packages – Pumps, Vessels, Exchangers, Fans

Scope: Layout, Member sizing, Weight, Center of Gravity, Foundation loadings, Wind & Seismic loads.

Onsite Equipment Installation Supervision

Automated Paint Blending System – Georgia
Chemical Plant Air Pollution Scrubber System – South Carolina
Refinery Air Pollution Scrubber System – Virginia
Boiler Plant Air Pollution Scrubber System – Pennsylvania
Scrubber Pilot Plant Removal – Mississippi, New Jersey